
In an office building nobody notices the chiller until it fails on the first hot day. We keep rooftop and plant room chillers ready with planned inspections.
Facility managers do not need surprises in June. They need a plant that was checked before the season, complete records for the owner and a contact who knows the installation. This page shows how we look after chillers in office buildings, hotels and shopping centres.
What is different about chillers in office buildings
- Seasonal operation. The unit stands still in winter and has to start reliably in spring.
- Part load. On most days it runs far below its rating, which stresses controls and compressors in a different way than full load.
- Rooftop location. Noise, access and weather decide when and how work can be done.
- Many parties. Owner, manager, tenants and the building management system expect agreed dates and clear reports.
The inspection before the cooling season
The most important visit takes place in March or April. We check and measure:
- alarm history, set points and running hours in the controller,
- pressures, superheat and subcooling in each refrigerant circuit,
- oil level, crankcase heaters and compressor current,
- condition of the condenser and operation of the fans,
- flow, strainers and glycol content on the water side,
- the safety chain: high pressure, low pressure, flow and frost protection.
The full list is on the page what we measure during a chiller inspection. Condenser cleaning is planned for the same visit, see condenser cleaning.
F-gas: leak checks and records
Operators are responsible for regular leak checks. The interval depends on the charge in tonnes of CO2 equivalent. We carry out the check, enter it in the equipment log and point out the next due date. Details are on the page F-gas leak checks.
After the season: preparing for winter
In autumn we check frost protection, heaters and glycol content and set the unit to winter mode. Where water without glycol stays in the evaporator, we drain it or protect it with trace heating. The steps are described in how to prepare a chiller for winter.
Inspection contract instead of single orders
For buildings with fixed budgets we offer inspection contracts. They include the agreed visits in spring and autumn, the leak checks and a report with readings after each visit. Repairs are offered separately, with the cause and the readings, so that the owner can follow every decision. We do not offer a standby service. We work Monday to Saturday from 8:00 to 16:00.
Prices
A diagnosis on site has a fixed price of 800 EUR net. Labour is charged at 115 EUR per hour and travel at 0.75 EUR per kilometre. For inspection contracts you receive an offer based on the number and size of the units.
Questions from building operators
How often should a chiller in an office building be inspected?
Do you work on rooftop units without lift access?
Does the owner receive a report?
Can you connect the chiller to the building management system?
Chiller in an office building due for a check before the season?
Send us the nameplate, the location and the last alarm text. We reply with a date and an offer.
